Loosen Garage Door Spring

Take note of the notches and screws that hold the torsion spring in place.

Loosen garage door spring.

Disconnect the garage door opener so the door remains closed. Through the use of pulleys they perform the same function as the torsion springs. Close the garage door. It should be placed on the left hand side of the torsion spring and placed away from the garage door s center.

The springs are located at the top inside part of the garage door. Pull downward on the spring and reattach the hook at the lower end of the spring at the next link down the chain to increase the spring tension. There are two torsion springs at each side of the garage door. Unplug the opener if you have an automatic garage door.

Adjust the springs on both sides of the door the same way. Getting a white lithium grease compound. The door opener should have a rope attached to the garage door mechanism. Once the spring is free of tension remove from its track hanger.

Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. Locate a reddish color cone around the spring. They come under tension when the garage door is closed to make lifting the. Pull this rope to release the door opener from the drive chain.

Put on eye. They give you more freedom to evenly coat hinges locks gears and springs. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. Step 2 when the door is lowered the springs that raise the door are under tension.

If it was opening too quickly move it to the next lower hole. The torsion spring helps the garage door open and close easily. Retest the door balance as you did in step 1. Reattach the hook at the next link up to loosen the.

The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Side mounted springs are long heavy springs mounted on each side of the upper garage door track. Call a professional if you don t feel confident dealing with a spring under this much tension. If you want to remove standard garage torsion springs yourself follow this video s instructions.

Step 1 unplug the garage door opener and clamp the door to the track. The springs will be under tension which increases the risk of injury. This tension makes it easier to lift the garage door from its closed position. If the door was closing too quickly move the spring to the next higher hole on the bracket.

Garage door lubricants that are grease based go on by hand and are much messier.